Kira
Starting Member
1 Posts |
Posted - Apr 08 2004 : 03:52:46 AM
|
When I install Visual Assist X on a system where Visual C++ 6 was installed but never ran, I get this message box when I enter Visual C++ (so for the first time) :
"Visual Assist was unable to find a system include path. Press ok to add an include path manually."
This problem does not happen when I run Visual C++ 6 (even once), before installing VAX.
It would be good if VAX installer could figure out the include paths without requiring to launch Visual C++ first.
Thanks. |
|