|
Eric
Starting Member
1 Posts |
 Posted - Apr 27 2010 : 10:51:42 PM
|
It would be very helpful for my team's diagnostic software to be able to use Visual Assist automation to go to a symbol. Right now the .net interface only supports activating the 'go to symbol' dialog; if this could just be extended a tiny bit to allow the caller to provide the symbol to go to, which would pop up the dialog if there is any ambiguity, that would be very helpful. A parameter to control going to the declaration or implementation would also be appreciated but I'd probably only use the 'go to implementation' mode anyway.
Thanks
|
|
Automation support for go to symbol command
