You must be registered to post a reply. Click here to register.
T O P I C R E V I E W
Eric
Posted - Apr 27 2010 : 10:51:42 PM It would be very helpful for my team's diagnostic software to be able to use Visual Assist automation to go to a symbol. Right now the .net interface only supports activating the 'go to symbol' dialog; if this could just be extended a tiny bit to allow the caller to provide the symbol to go to, which would pop up the dialog if there is any ambiguity, that would be very helpful. A parameter to control going to the declaration or implementation would also be appreciated but I'd probably only use the 'go to implementation' mode anyway. Thanks
1 L A T E S T R E P L I E S (Newest First)
feline
Posted - Apr 29 2010 : 2:52:04 PM I am not quite sure I understand what you are after here. Are you trying to automate the IDE via IDE macro's or some similar system?